How to Use Pneumatic Tools Safely in the Workplace

!±8± How to Use Pneumatic Tools Safely in the Workplace

When it comes to using pneumatic tools, or tools that are powered by compressed air, it is very important to know how to use them safely. The compressed air that powers these tools can cause a lot of damage if you are not careful, especially if you're using a pneumatic nailer, drill, or jack hammer.

Accidents with pneumatic appliances do happen and will happen if the correct safety measures are not taken. Here are some safety tips to keep in mind:

· Fully read the instruction manual before you start using the appliance. Even if you've used a similar tool before, it's always best to know exactly how it operates, especially in the event of an emergency.
· Always wear necessary safety equipment, including safety glasses and gloves, when appropriate. Do not allow anyone to operate your appliances without the required safety gear (this is not only unsafe but it also may make you liable for any damages done).
· Never aim or point tools, especially nailers or staplers, at another person.
· If you'll be using tools near other workers, you may need to set up screens so they will not be hit by any flying debris or exposed to excessive amounts of dust.
· Keep your tools as clean as possible and always make certain they are well lubricated so they run at peak efficiency and do not get jammed or clogged up.
· Use only the attachments recommended for each pneumatic tool. Do not mix and match different attachments and never force an attachment onto a tool.
· Never operate your tool at an air pressure above the maximum amount listed by the manufacturer.
· Don't create hazards by running the air hose across walkways or around areas that contain sharp objects or other hazards.
· Never carry a pneumatic tool by the air hose.
· Always turn off the air pressure when you are not using your tool or when you're changing tools.

There are also some important safety procedures for handling air hoses, as well.

· Always use the correct diameter fittings and hose-never try to make the wrong sized hose work.
· Regularly inspect your air hoses for breaks or abrasions and replace damaged hoses promptly.
· Be sure to blow out the line before you connect it by holding it away from you.
· Only use hoses that are designed for pneumatic tools-they are specially made to resist breaking and are made extra flexible.
· Likewise, only use hoses with a minimum working pressure rating of 150 psig or hoses that can handle 150% of the maximum pressure your tools use. Go with whichever number is higher.
· Never use an air compressor to blow away dirt or other debris, especially not from your clothing. Cleaning using compressed air can be very dangerous.

Many of these safety procedures may seem obvious to you, but not everyone takes the same level of care when using potentially dangerous appliances. Make sure that the people around you who are using pneumatic tools follow these procedures.